Vescom 2000 adhesive is intended for the processing of textile wallcovering
and vinyl wallcovering heavier than
Depending upon the conditions, such as the temperature and/or condition of the substrate or the specification, the adhesive may be diluted with a maximum of 6% water. Before use, stir the adhesive 2000 thoroughly and apply using a short-pile synthetic sheepskin roller.
Remove residual adhesive on vinyl wallcovering immediately by using clean water and drying afterwards. Ensure that no spots of water or adhesive stain the wallcovering. For further information, consult the general hanging instructions for Vescom vinyl and textile wallcovering. The adhesive must not be exposed to extreme temperature fluctuations. Vescom adhesive 2000 is frost-resistant up to -10°C.
textile wallcovering: ± 4-5 m²/kilo
vinyl wallcovering: ± 5 m²/kilo
The adhesive should only be used in well-ventilated areas. If the adhesive comes into contact with your eyes or is ingested through the mouth, immediately rinse with plenty of water and consult a doctor if necessary. For additional information consult the safety information sheet.