Vescom 2500 

Vescom 2500 adhesive can be used to hang floor-to-ceiling digital printed wallcovering that weighs 380 g/m² or more.*


The adhesive is ready for use and should not be diluted. Before use, stir the adhesive thoroughly and apply it using a short haired synthetic roller. Remove residual adhesive on wallcovering immediately with clean water and dry the same off.


For further information, consult the hanging instructions for Vescom digital printed wallcovering. The adhesive should be stored at a relatively stable temperature. Vescom adhesive is frost-resistant up to -10°C.


± 4-5 m²/kilo


shelf life

9 months


safety instructions

The adhesive should only be used in well-ventilated areas. If the adhesive comes into contact with your eyes or is ingested through the mouth, immediately rinse with plenty of water. Consult a doctor if in any doubt. For additional information, please refer to the safety information sheet on the Vescom website.


* Alternatively you may use a 1:1 mix of Vescom 2000 and Vescom 3000.

documents - technical information