Vescom 3000 

Vescom 3000 adhesive is only intended for the processing of vinyl and textile wallcovering on permanently sealed (non-breathing) substrates, for example, pretreated or galvanised metal, plastics and painted substrates. Untreated metal must be pre-treated with an anti-rust solution.


Before use, stir the adhesive 3000 thoroughly, do not dilute and apply using a short-pile synthetic sheepskin roller.


Remove residual adhesive by using clean water and drying afterwards. For additional information consult the general processing instructions - Vescom vinyl and textile wallcovering. Do not expose adhesive to extreme temperature fluctuations. Vescom adhesive 3000 is frost-resistant up to -10°C.


textile wallcovering: ± 5-7 m²/kilo

vinyl wallcovering: ± 4-5 m²/kilo


shelf life

9 months


safety instructions

The adhesive should only be used in well-ventilated areas. If the adhesive comes into contact with your eyes or is ingested through the mouth, immediately rinse with plenty of water and consult a doctor if necessary. For additional information consult the safety information sheet.

documents - technical information